Allied Telesis AT-S60 - Manual (Page 462)

AT-S60 Management Software User’s Guide
Section IV: Web Browser Management 461
Setting a Switch’s Enhanced Stacking Status
To adjust a switch’s enhanced stacking status, perform the following
procedure:
1. From the Home Page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 155 on page 434.
2. From the Configuration menu, select the Layer 2 option.
The Layer 2 page is displayed with the MAC Address tab selected
by default, as shown in Figure 204 on page 541.
3. Select the Enhanced Stacking tab.
The Enhanced Stacking tab is shown in Figure 165.
Figure 165 Configuration Layer 2 Page, Enhanced Stacking Tab
4. Click the desired enhanced stacking status for the switch.
5. Click Apply.
The new enhanced stacking status is immediately activated on
the switch.
6. From the Configuration menu, select the System option.
The System page is displayed with the General tab shown by
default.
7. Click Save Changes.
The changes you made are saved on the switch.