Allied Telesis AT-S60 - Manual (Page 449)

Chapter 27: Basic Switch Parameters
Section IV: Web Browser Management 448
Access Mode
Click Read Only to allow read access to the SNMP community. To
allow read-write access to the SNMP community, click Read-Write.
Allow Any Station
Click this option to allow any SNMP manager to access the switch.
When you click this option, a warning message appears on the
screen. Click OK to continue.
Manager IP Address1 through Manager IP Address 8
Enter an IP Address of a switch that is permitted SNMP manager
access to the current switch. You can enter up to 8 Manager IP
Addresses.
Trap Receiver IP Address 1 through Trap Receiver IP Address 8
Use the above selections to specify the IP addresses of up to 8 trap
receivers on your network that can receive traps from the switch.
7. Click Apply to update the SNMP page.
To save your changes, return to the General tab and click Save
Changes.
Modifying an
SNMP
Community
To modify an SNMP community perform the following procedure:
1. From the Home Page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 155 on page 434.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 158 on page 445.
3. To make changes to a current SNMP community, click on the circle
next to the community name on the SNMP page. Then click Modify.
The Modify SNMP page is shown in Figure 160.