Allied Telesis AT-S60 - Manual (Page 280)

AT-S60 Management Software User’s Guide
Section II: Local and Telnet Management 279
Selecting a VLAN Mode
The following procedure explains how to select a VLAN mode on an
AT-8400 Series Switch.
Note
You should create a backup file of the configuration of the switch
before changing the switch to a Multiple VLAN mode. Changing the
VLAN mode automatically deletes any port-based or tagged VLANs
that you created on the switch.
1. From the Main Menu, type 2 to select VLAN Menu.
The VLAN Menu is displayed as shown in Figure 91 on page 257.
2. From the VLAN Menu, type 1 to select Configure VLAN.
The Configure VLAN Menu is displayed as shown in Figure 94 on page
260.
3. From the Configure VLAN Menu, type 2 to select Set VLAN Mode.
The following prompt is displayed:
Enter VLAN Mode (U-User Configured, Q-Multiple
802.1Q, M-Multiple) ->
4. Select one of the following:
U - Activates the user configuration mode. Select this value to create
your own port-based and tagged VLANs. This is the default setting.
Q - Activates the Q-802.1Q Multiple VLAN mode.
M - Activates the non-802.1Q compliant multiple VLANs mode.
If you selected a multiple VLAN mode, the following prompt is
displayed:
Please backup current configuration before changing
to multiple VLAN mode:
Do you want to continue? [Y/N]
5. Enter Y to continue or N to cancel the procedure.
If you selected a Multiple VLAN mode, the following prompt is
displayed:
Enter uplink port-list:
6. Enter the number of the port on the switch to function as the uplink
port for the other ports. You can specify only one port.