Allied Telesis AT-S60 - Manual (Page 132)

AT-S60 Management Software User’s Guide
Section II: Local and Telnet Management 131
Enabling a Destination Port Mirror
Use this procedure if you have previously disabled a destination port
mirror (see Disabling a Destination Port Mirror on page 132) and you
want to make it active again.
To enable a destination port mirror, perform the following procedure:
1. From the Main Menu, type 1 to select Port Menu.
The Port Menu is shown in Figure 25 on page 89.
2. From the Port Menu, type 5 to select Port Mirroring.
The Port Mirroring menu is shown in Figure 38 on page 126.
3. Type 4 to select Enable Mirror.
The following prompt is displayed.
Enter Destination Port [port-list, all]:
4. Enter the mirror port that you want to enable and press Return.
port-list
For information about how to specify ports, see Specifying Ports
on page 31.
all
Use this selection to enable all the mirror ports listed on the Port
Mirroring Menu.
At the top of the Port Mirroring menu, the Status column changes
to Enabled.
Note
By default, the mirror is enabled when it is created.
5. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
The port mirror (or port mirrors) is now enabled.