Allied Telesis AT-S60 - Manual (Page 68)

AT-S60 Management Software User’s Guide
Section II: Local and Telnet Management 67
Configuring the Console Startup Mode
You can configure the AT-S60 software to display either the Main Menu
or the command line interface prompt (#) when you start a local or
Telnet management session. The default is the Main Menu.
To change the console startup mode, perform the following procedure:
1. From the Main Menu, type 5 to select the System Menu.
The System Menu is shown in Figure 5 on page 47.
2. From the System Menu, type 1 to select Configure System.
The Configure System menu is shown in Figure 9 on page 52.
3. From the Configure System Menu, type 1 to select Configure System
Software.
The Configure System Software menu is shown in Figure 10 on
page 53.
4. Type 4 to select Console Startup Mode.
You can toggle between the Menu and CLI values. Menu is the
default. Select Menu to start a management session with the Main
Menu when you log in. Select CLI to start a management session
with the Command Line Interface when you log in.
5. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Your changes to the console startup mode take effect the next
time you start a management session.