Allied Telesis AT-S60 - Manual (Page 498)

AT-S60 Management Software User’s Guide
Section IV: Web Browser Management 497
Note
If you do not want to change the active spanning tree protocol and
just want to enable or disable it, go to Step 5.
4. To change the active spanning tree protocol on the switch, click STP,
RSTP, or MSTP in the Active Protocol Version section of the tab. The
default is RSTP.
Note
Only one spanning tree protocol can be active on the switch at a
time.
5. To enable or disable the active spanning tree protocol on the switch,
click the Enable Spanning Tree check box. A check indicates that the
spanning tree is enabled while no check indicates that spanning tree
is disabled. The default is disabled.
6. Click Apply.
Note
If you changed the active spanning tree protocol, the switch resets
and your management session is ended. To continue managing the
switch, you must restart your management session after the switch
is finished reloading the AT-S60 management software.
7. If you activated STP, go to Configuring STP on page 498. If you
activated RSTP go to Configuring RSTP on page 502. If you activated
MSTP, go to Configuring MSTP on page 507.