Allied Telesis AT-S60 - Manual (Page 330)

AT-S60 Management Software User’s Guide
Section II: Local and Telnet Management 329
Displaying a List of Host Nodes
This procedure displays a list of the multicast groups on a switch, as well
as the host nodes. To display the list, perform the following procedure:
1. From the IGMP Snooping Configuration Menu, type 6 to select View
Multicast Hosts List.
(For instructions on how to display the IGMP Snooping
Configuration Menu, perform Steps 1 to 4 of Configuring IGMP
Snooping on page 326.)
The View Multicast Hosts List Menu is shown in Figure 118.
Figure 118 View Multicast Hosts List Menu
The information in this menu is for viewing purposes only. The
columns are defined below:
Multicast Group
The multicast address of the group.
VLAN
The VID of the VLAN where the port is an untagged member.
Membership Port
A port on the switch where one or more host nodes of the
multicast group are connected.
HostIP
The IP address(es) of the host node(s) connected to the port.
Status
The status of the host node. The status can be either Active,
meaning the node is an active member of a multicast group, or
Left Group, meaning the node has recently left the group.
Allied Telesyn AT-8400 Series - ATS60 V2.0.0
High School Switch 142
User: Manager 00:14:33 01-Jan-2003
View Multicast Hosts List
=================================================
MulticastGroup VLAN
Port HostIP Status
=================================================
U - Update Display
R - Return to Previous Menu
Enter your selection?