Allied Telesis AT-S60 - Manual (Page 447)

Chapter 27: Basic Switch Parameters
Section IV: Web Browser Management 446
3. Adjust the following parameters as desired:
Enable SNMP Access
Use this parameter to enable the switch to be remotely managed
with an SNMP application program.
Note
If the check box in the Enable SNMP Access box is empty, the switch
cannot be managed through SNMP. This is the default.
Enable Authentication Failure Trap
Use this selection to allow trap receiver IP addresses to be
specified. When this field is selected and the switch receives an
unauthenticated request, an authentication failure trap is sent to
the trap receivers configured on the switch.
4. Click Apply to display your changes in the Status column of the SNMP
tab.
5. To add an SNMP Community to the current list, click Add.