Allied Telesis AT-S60 - Manual (Page 184)

AT-S60 Management Software User’s Guide
Section II: Local and Telnet Management 183
Note
You can update only AT-8400 Series switches. You cannot download
AT-S60 management software onto an AT-8000 Series switch.
The following prompt is displayed:
Do you want to show remote switch burning flash ->
[Yes/No]
You can use this prompt to view system messages as the software
image is stored to flash memory.
6. You can respond with Yes or No to this prompt. It does not affect the
download.
The following prompt is displayed:
Do you want confirmation before downloading each
switch -> [Yes/No]
If you are updating multiple switches, answering Yes to this
prompt causes the management software to display a
confirmation message before it upgrades a switch. If you answer
No, the master switch downloads without a confirmation
message.
The management software begins the download. The
management software notifies you when the download is
complete.
Caution
After a switch image file has been downloaded, the switch must
write it to flash memory. This requires one to two minutes to
complete. Do not reset or power off the switch while it is writing the
file. After the file has been written to flash memory, the switch
automatically resets.