Allied Telesis AT-S60 - Manual (Page 117)

Chapter 8: Port Trunking
Section II: Local and Telnet Management 116
Deleting a Port Trunk
Use this procedure to delete an existing port trunk, including the trunk
ID, name, and ports associated with the port trunk.
Caution
Before performing the following procedure, disconnect the cables
from the port trunk on the switch. Deleting a port trunk with the
cables attached can create loops in your network topology. Data
loops can result in broadcast storms and poor network
performance.
To delete a port trunk from the switch, perform the following procedure:
1. From the Main Menu, type 1 to select Port Menu.
The Port Menu is shown Figure 25 on page 89.
2. From the Port Menu, type 4 to select Port Trunking.
The Trunk Configuration menu is shown in Figure 36 on page 114.
3. Type 2 to delete a trunk.
The following prompt is displayed:
Enter Trunk ID: [1 to 22] -> 1
4. Enter the trunk ID number of the port trunk you want to delete and
press Return.
After you delete a trunk, the following message is displayed:
Please wait while Trunk is being deleted...Done!
Press any key to continue
5. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
You have successfully deleted the port trunk from the switch.