Allied Telesis AT-S60 - Manual (Page 446)

AT-S60 Management Software User’s Guide
Section IV: Web Browser Management 445
Configuring the SNMP Parameters and Trap IP Addresses
This procedure allows you to create SNMP communities that have access
to the switch. In creating an SNMP community, you can specify up to
eight IP addresses of management stations that can access the switch. In
addition, you can specify up to eight trap receiver IP addresses of trap
receivers that can receive unauthenticated failure trap messages from
the switch. The following procedure permits you to modify current
SNMP community parameters as well as delete SNMP community
access.
Configuring
SNMP
Communities
To configure SNMP communities perform the following procedure.
1. From the Home Page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 155 on page 434.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 158.
Figure 158 Configuration System Page, SNMP Tab