Allied Telesis AT-S60 - Manual (Page 200)

AT-S60 Management Software User’s Guide
Section II: Local and Telnet Management 199
The STP Menu is shown in Figure 68.
Figure 68 STP Menu
3. Adjust the bridge STP settings as needed. The parameters are
described below.
1 - Bridge Priority
The priority number for the bridge. This number is used in
determining the root bridge for RSTP. The bridge with the lowest
priority number is selected as the root bridge. If two or more
bridges have the same priority value, the bridge with the
numerically lowest MAC address becomes the root bridge. When
a root bridge goes off-line, the bridge with the next priority
number automatically takes over as the root bridge. This
parameter can be from 0 (zero) to 61,440 in increments of 4096,
with 0 being the highest priority. For a list of the increments, refer
to Table 5, Bridge Priority Value Increments on page 187.
2 - Bridge Hello Time
The time interval in seconds between generating and sending
configuration messages by the bridge. This parameter can be
from 1 to 10 seconds. The default is 2 seconds.
3 - Bridge Forwarding
The waiting period in seconds before a bridge changes to a new
state, for example, becomes the new root bridge after the
Allied Telesyn AT-8400 Series - ATS60 V2.0.0
High School Switch 142
User: Manager 00:14:33 15-Jan-2003
STP Menu
1 - Bridge Priority ..... 32768
2 - Bridge Hello Time ... 2
3 - Bridge Forwarding ... 15
4 - Bridge Max Age ...... 20
5 - Bridge Identifier ... 00:30:84:EE:31:01
P - STP Port Parameters
R - Reset STP to Defaults
R - Return to Previous Menu
Enter your selection?: