Allied Telesis AT-S60 - Manual (Page 313)

Chapter 16: MAC Address Table
Section II: Local and Telnet Management 312
2 - Display All static MAC Addresses
This option displays only the static MAC addresses. The columns
in the menu are the same as those in the Display All MAC
Addresses Menu. For definitions of the columns, refer to Table 14
on page 311.
3 - Display MAC addresses by Port
You can use this option to view the MAC addresses that have been
learned on a particular port. When you select this option, the
following prompt is displayed:
Enter port-list:
Enter the ports. For information on entering ports, refer to
Specifying Ports on page 31. The management software
responds by listing only those addresses learned on the specified
ports.
4 - Display the Port of MAC Address
In some situations, you might want to know which port learned a
particular MAC address. You could display the entire MAC address
table and scroll through the list looking for the MAC address. But
if the switch is part of a large network, finding it could prove
difficult.
Instead, you can use this option. When you select this option, the
following prompt is displayed:
Please enter MAC address:
After you enter the MAC address and press Return, the following
prompt is displayed:
Please enter a VLAN ID: [1 to 4094] ->
Enter a VLAN ID and press Return. Then the management
software displays the number of the port where it learned the
address.
5 - Display MAC Addresses by VLAN ID
This option is useful if you created VLANs on the switch and want
to view the MAC addresses of the nodes of a particular VLAN. (This
procedure is not of much value if the switch contains only the
Default VLAN, in which case displaying the entire MAC address
table, produces the same result.)
To use this option, you need to know the VID number of the VLAN
whose MAC addresses you want to view. (To view VLAN VIDs, refer
to Displaying VLANs on page 257.) When you select the option,
the following prompt is displayed:
Please enter a VLAN ID: [1 to 4094] ->
After you have entered the VID and press Return, the
management software displays all of the static and dynamic MAC
address of the corresponding VLAN.