Allied Telesis AT-S60 - Manual (Page 471)

Chapter 29: Port Parameters
Section IV: Web Browser Management 470
Flow Control
Flow control applies only to ports operating in full-duplex mode.
The switch uses a special pause packet to stop the end node from
sending frames. The pause packet notifies the end node to stop
transmitting for a specified period of time.
To select a value, click the circle next it. Possible values are:
❑ Auto - Indicates the port conforms to the flow control setting of
the end node. For example, if flow control is active on the end
node then flow control is active on this port. Also, if flow control is
not active on the end node, then flow control is not active on this
port. This is the default.
❑ Disabled - Indicates that no flow control occurs on the port.
❑ Enabled - Indicates that flow control occurs on the port.
MDI/MDIX Crossover
The operating configuration of the port. Auto indicates that the
port automatically determines the appropriate MDI or MDI-X
setting.
6. Once you have made the desired changes, click Apply.
You are returned to the Port Settings tab as shown in Figure 168
on page 466.
7. After you have set the parameters, click Apply.
Your changes are activated on the switch.
To save your changes, return to the General tab and click Save
Changes. The changes you made are saved on the switch.