Allied Telesis AT-S60 - Manual (Page 72)

AT-S60 Management Software User’s Guide
Section II: Local and Telnet Management 71
Configuring SNMP Communities
Use this procedure to configure the SNMP community strings for the
switch. You can assign SNMP community names. In addition, you can
assign up to eight IP addresses of management stations and up to eight
IP addresses of trap receivers.
Use the following procedure to configure SNMP.
1. From the Main Menu, type 5 to select System Menu.
The System Menu in shown in Figure 5 on page 47.
2. From the System Menu, type 1 to select Configure System.
The Configure System Menu is shown in Figure 9 on page 52.
3. From the Configure System Menu, type 1 - Configure System
Software.
The Configure System Software Menu is shown in Figure 10 on
page 53.
4. From the Configure System Software Menu, type 8 to select
Configure SNMP.
The Configure SNMP Menu is shown in Figure 17 on page 70.
5. Select 3 - Configure SNMP Community to configure SNMP
parameters.
The Configure SNMP Community menu is shown in Figure 18.
Figure 18 Configure SNMP Community Menu
Allied Telesyn AT-8400 Series - ATS60 V2.0.0
High School Switch 142
User: Manager 00:14:33 15-Jan-2003
Configure SNMP Community
Community Name Access Mode Status OpenAcc Manager IP Address Trap Receiver IP
====================================================================================
private Read|Write Enabled No 147.35.18.87
public Read Only Enabled No 147.35.18.88
1 - Create SNMP Community
2 - Delete SNMP Community
3 - Modify SNMP Community
U - Update Display
R - Return to Previous Menu
Enter your selection?