Allied Telesis AT-S60 - Manual (Page 71)

Chapter 4: SNMP Community Strings
Section II: Local and Telnet Management 70
4. From the Configure System Software Menu, type 8 to select
Configure SNMP. The Configure SNMP Menu is shown in Figure 17.
Figure 17 Configure SNMP Menu
5. Select 1 - SNMP Status to enable or disable SNMP management on
your switch.
Toggle between Enabled and Disabled by pressing 1 again.
6. Select 2 - Authentication Failure Trap Status to configure the switch
to send an authentication failure trap to trap receiver hosts. When this
parameter is enabled, the switch sends an authentication failure trap
under two conditions:
- The SNMP management station attempts to access the switch
using an incorrect or invalid community name
- The IP address of this SNMP management station is not
configured as an SNMP manager within the community.
Toggle between Enabled and Disabled by pressing 2 again. If you
do not configure a trap receiver IP address, no trap message is
sent.
Enabled - Sends authentication failure traps to IP addresses of
configured trap receiver hosts.
Disabled - Does not send authentication failure traps.
7. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Changes to the SNMP parameters are immediately activated on
the switch.
Allied Telesyn AT-8400 Series - ATS60 V2.0.0
High School Switch 142
User: Manager 00:14:33 15-Jan-2003
Configure SNMP
1 - SNMP Status ........................... Disabled
2 - Authentication Failure Trap Status..... Disabled
3 - Configure SNMP Community
4 - Display SNMP Community
R - Return to Previous Menu
Enter your selection?