Allied Telesis AT-S60 - Manual (Page 295)

Chapter 15: GARP VLAN Registration Protocol
Section II: Local and Telnet Management 294
Enabling or Disabling GVRP on a Port
This procedure enables and disables GVRP on a switch port. The default
setting for GVRP on a port is enabled. Only those ports where GVRP is
enabled transmit PDUs.
Note
Allied Telesyn recommends disabling GVRP on unused ports and
those ports that are connected to GVRP-inactive devices. This is to
protect against unauthorized access to restricted areas of your
network. For further information, refer to GVRP and Network
Security on page 287.
1. From the Main Menu, type 2 to select VLAN Menu.
The VLAN Menu is shown in Figure 91 on page 257.
2. From the VLAN Menu, type 3 to select Configure GARP-GVRP.
The GARP-GVRP menu is shown in Figure 101 on page 292.
3. Type P - GVRP Port Parameters to configure the switch ports.
The GVRP Port Parameters Menu is shown in Figure 102.
Figure 102 GVRP Port Parameters Menu
4. Type 1 to configure GVRP Port Settings.
The following prompt is displayed:
Enter port-list:
Allied Telesyn AT-8400 Series - ATS60 V2.0.0
High School Switch 142
User: Manager 00:14:33 24-May-2003
GVRP Port Parameters
1 - Configure GVRP Port Settings
2 - Display GVRP Port Configuration
R - Return to Previous Menu
Enter your selection?