Allied Telesis AT-S60 - Manual (Page 400)

AT-S60 Management Software User’s Guide
Section III: Security Features 399
Enabling TACACS+ or RADIUS
To enable or disable the server-based authentication feature on the
switch and to configure the TACACS+ and RADIUS settings, perform the
following procedure:
1. From the Main Menu, type 6 to select Security Menu.
The Security Menu is shown in Figure 30 on page 105.
2. From the Security Menu, select Server Based Authentication.
The Authentication Menu is shown in Figure 137.
Figure 137 Authentication Menu
3. To enable or disable the authentication feature on the switch, type 1
to select Server-based Authentication. The following prompt is
displayed:
Server Based User Authentication (E-Enabled, D-
Disabled) ->
4. Type E to enable the TACACS+ and RADIUS protocols on the switch or
D to disable them. The default is disabled.
If you enable the authentication feature, continue to the next
step. If you disabled authentication, press R twice to return to the
Main Menu. Then select S - Save Configuration Changes.
5. To select an authentication protocol, type 2 to select Authentication
Method. The following prompt is displayed:
Enter T-TACACS+, R-RADIUS ->
6. Type T to select TACACS+ or R for RADIUS. The default is TACACS+.
Only one protocol can be active at a time.
Allied Telesyn AT-8400 Series - ATS60 V2.0.0
High School Switch 142
User: Manager 00:14:33 01-Jan-2003
Authentication Menu
1 - Server-based Authentication ..... Disabled
2 - Authentication Method ........... TACACS+
3 - TACACS+ Configuration
4 - RADIUS Configuration
R - Return to Previous Menu
Enter your selection?