Allied Telesis AT-S60 - Manual (Page 205)

Chapter 12: STP, RSTP, and MSTP
Section II: Local and Telnet Management 204
Configuring RSTP
This section contains the following procedures:
❑ Configuring RSTP Bridge Settings on page 204
❑ Configuring RSTP Port Parameters on page 207
Configuring
RSTP Bridge
Settings
This section contains the procedure for configuring a bridge’s RSTP
settings.
Caution
The default RSTP parameters are adequate for most networks.
Changing them without prior experience and an understanding of
how RSTP works might have a negative effect on your network. You
should consult the IEEE 802.1w standard before changing any of the
RSTP parameters.
Note
You cannot configure RSTP settings unless the protocol has been
selected as the active spanning tree protocol on the switch. For
instructions, refer to Enabling or Disabling STP, RSTP, or MSTP on
page 196.
1. From the Main Menu, type 3 to select Spanning Tree Menu.
The Spanning Tree Menu is shown in Figure 67 on page 196.
2. From the Spanning Tree Menu, type 4 to select RSTP Configuration.