Allied Telesis AT-S60 - Manual (Page 385)

Chapter 22: Secure Sockets Layer (SSL)
Section III: Security Features 384
Configuring SSL
This section describes how to configure SSL. This procedure is part of a
comprehensive procedure to create certificates on the switch. See
Configuring SSL Certificates on page 337 for a list of all the procedures
you must complete to create certificates on the switch.
To configure the SSL protocol, perform the following procedure:
1. From the Main Menu, type 6 to select Security Menu.
The Security Menu is shown in Figure 30 on page 105.
2. From the Security menu, select the Secure Socket Layer (SSL) menu.
The Secure Socket Layer (SSL) Menu is shown in Figure 134.
Figure 134 Secure Socket Layer (SSL) Menu
3. Select 1 - Maximum number of Sessions to increase the number of
sessions.
Enter a value from 1 to 100. The maximum number of sessions is
used to speed up a connection. By increasing the number of
sessions, you increase HTTPS performance. However, increasing
the number of sessions also increases the memory requirements.
The default is 50.
4. Select 2 - Session Cache Timeout to increase or decrease the timer
that determines when the session cache times out.
Enter a value, in seconds, from 1 to 600. The default is 300
seconds.
Allied Telesyn AT-8400 Series - ATS60 V2.0.0
High School Switch 142
User: Manager 00:14:33 30-Apr-2003
Secure Socket Layer (SSL)
1 - Maximum Number of Sessions......... 50
2 - Session Cache Timeout.............. 300 seconds
R - Return to Previous Menu
Enter your selection?