Allied Telesis AT-S60 - Manual (Page 455)

Chapter 27: Basic Switch Parameters
Section IV: Web Browser Management 454
Returning the AT-S60 Software to the Factory Default Values
The procedure in this section returns all AT-S60 software parameters,
except the IP address, subnet mask, and gateway address, to their
default values. This procedure also deletes any VLANs that you have
created on the switch.
Note
The AT-S60 software default values are described in Appendix A,
AT-S60 Default Settings on page 585.
To return the AT-S60 management software to its default settings,
perform the following procedure:
1. From the Home Page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 155 on page 434.
2. Select the System Maintenance tab.
The System Maintenance tab is shown in Figure 163.
Figure 163 Configuration System Page, System Maintenance Tab