Allied Telesis AT-S60 - Manual (Page 77)

Chapter 4: SNMP Community Strings
Section II: Local and Telnet Management 76
7. Select 1 - Add Attributes to Community to add SNMP manager and
Trap Receiver IP addresses. You can add up to eight IP addresses for
SNMP Managers. Additionally, you can add up to eight Trap Receiver
IP Addresses.
The following prompt is displayed:
Enter SNMP Community Name:
8. Enter a SNMP community name from the list at the top of the menu
and press Return. The SNMP community names are case sensitive.
The following prompt is displayed:
Enter SNMP Manager IP Addr:
9. Enter an IP address to permit the SNMP manager to access the switch.
Press Return.
Use the following format for an IP address:
XXX.XXX.XX.XXX
Or, to skip this prompt, press Return.
The following prompt appears:
Enter Trap Receiver IP Addr:
10. Enter an IP address to send trap messages. Press Return.
Use the following format for an IP address:
XXX.XXX.XX.XXX
Or, to skip this prompt, press Return.
The display at the top of the Configure SNMP Community menu is
updated to reflect your changes.
11. Select 2 - Delete Attributes from Community to delete an IP address
from the SNMP manager or a trap receiver.
The following prompts appear:
Enter SNMP Community Name:
Enter SNMP Manager IP Addr:
See Steps 6 through 8 for information about specifying these
attributes. Enter the information and press Return.
A confirmation message appears:
Do you want to delete this SNMP Manager?
12. Enter Y to delete the IP address of this SNMP manager. Enter N to
retain the IP address of the SNMP manager. Then press Return.
The following prompt appears:
Enter the Trap Receiver IP address:
13. Enter the Trap Receiver IP address and press return.
The following confirmation message appears: