Allied Telesis AT-S60 - Manual (Page 518)

AT-S60 Management Software User’s Guide
Section IV: Web Browser Management 517
Displaying STP, RSTP, or MSTP Settings
To display spanning tree parameter settings, perform the following
procedure:
1. From the Home page, select Monitoring.
The Monitoring System page is displayed with the General tab
selected by default, as shown in Figure 157 on page 442.
2. Select the Layer 2 option.
The Monitoring Layer 2 page is displayed with the MAC Address
tab selected by default, as shown Figure 204 on page 541.
3. Select the Spanning Tree tab.
The Monitoring Spanning Tree tab is shown in Figure 193. This tab
displays whether spanning tree is enabled or disabled and which
spanning tree protocol is active.
Figure 192 Monitoring Layer 2 Page, Spanning Tree Tab
4. To view the current settings for the active spanning tree protocol,
click View.