Allied Telesis AT-S60 - Manual (Page 530)

AT-S60 Management Software User’s Guide
Section IV: Web Browser Management 529
Setting the Switch’s VLAN Mode
This section contains the procedure for setting a switch’s VLAN mode.
You can configure a switch to support port-based and tagged VLANs or
to operate in the Basic VLAN mode. A change to VLAN status is not
activated until you reset the switch.
Note
Refer to Chapter 13, Virtual LANs on page 240, for descriptions of
port-based and tagged VLANs and the Basic VLAN mode.
To set the switch’s VLAN mode, perform the following procedure:
1. From the Home Page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 155 on page 434.
2. In the Configuration section of the tab, Switch Mode selection, click
either Tagged or Basic.
If you select Tagged, which is the default, the switch supports
both port-based VLANs and tagged VLANs. If you select Basic, the
switch operates in the Basic VLAN mode.
3. Click Apply.
The following confirmation message is displayed:
The switch will be rebooted for the change to take
effect. This page will not be available while the
switch reboots. Continue anyway?
4. Select OK to continue with the reboot. Select Cancel to cancel the
reboot.
A change to VLAN status is not activated until you reset the
switch. To reset the switch, refer to Resetting a Switch on page
452.