Allied Telesis AT-S60 - Manual (Page 107)

Chapter 7: Port Security
Section II: Local and Telnet Management 106
3. Type 1 to select Configure Port Security.
The following prompt is shown:
Enter port-list:
4. Enter the port(s) you want to configure. Then press Return.
For information about how to specify ports, see Specifying Ports
on page 31.
The Configure Port Security Menu is shown in Figure 32.
Figure 32 Configure Port Security Menu
Note
A security mode of PA Controlled for a port means that the port is
functioning as a supplicant or authenticator of the port-based
network access feature, described in 802.1x Port-Based Network
Access Control on page 406. You cannot change the security mode
of a port if its security mode is PA Controlled with the Port Security
feature. To change the PA Controlled setting, you need to change
the configuration of a port-- removing its supplicant or
authenticator status.
5. Press 1 to change the port security on your specified port list.
The following prompt appears:
Enter new mode (A-Automatic, L-Limited, S-Secured,
K-locKed):
6. Select the desired security level by typing the corresponding letter
and then pressing Return. For definitions of the security levels, refer
to Port Security Overview on page 102.
If you selected Automatic, which disables port security, return to
the Main Menu to save your changes.
Allied Telesyn AT-8400 Series - ATS60 V2.0.0
High School Switch 142
User: Manager 00:14:33 15-Jan-2003
Configure Port Security
Configuring Port Security 3.1-2
1 - Security Mode ................ Automatic
D - Set Default Port Security
R - Return to Previous Menu
Enter your selection?