Allied Telesis AT-S60 - Manual (Page 550)

AT-S60 Management Software User’s Guide
Section IV: Web Browser Management 549
Configuring IGMP Snooping
To configure IGMP snooping from a web browser management session,
perform the following procedure:
1. From the Home Page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 155 on page 434.
2. Select the IGMP tab.
The Configuration IGMP tab is shown in Figure 207.
Figure 207 Configuration System Page, IGMP Tab
3. Adjust the IGMP parameters as necessary.
The parameters are explained below:
Enable IGMP Snooping
Enables and disables IGMP snooping on the switch. A check in the
box indicates that IGMP is enabled.
Multicast Host Topology
Defines whether there is only one host node per port or multiple
host nodes per port. Possible settings are Single-Host/Port (Edge)
and Multi-Hosts/Port (Intermediate).