Allied Telesis AT-S60 - Manual (Page 453)

Chapter 27: Basic Switch Parameters
Section IV: Web Browser Management 452
Resetting a Switch
To reset a switch, perform the following procedure:
1. From the Home Page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 155 on page 434.
2. Click the Reset button at the bottom of the page.
A confirmation prompt is displayed.
3. Click OK to reset the switch or Cancel to cancel the procedure.
Resetting the switch ends your web browser management
session. You must restart the session to continue managing the
switch.
Note
The switch does not forward traffic while it reloads the AT-S60
management software. This takes approximately 30 seconds to
complete.