Allied Telesis AT-S60 - Manual (Page 401)

Chapter 24: TACACS+ and RADIUS Protocols
Section III: Security Features 400
Configuring TACACS+
To configure TACACS+, perform the following procedure:
1. From the Main Menu, type 6 to select Security Menu.
The Security Menu is shown in Figure 30 on page 105.
2. From the Security Menu, select Server Based Authentication.
The Authentication Menu is shown in Figure 137 on page 399.
3. Type 3 to select TACACS+ Configuration.
The TACACS+ Client Configuration Menu is shown in Figure 138.
Figure 138 TACACS+ Client Configuration Menu
4. Configure the settings as needed. The settings are described below:
1 - TAC Server 1
2 - TAC Server 2
3 - TAC Server 3
Use these parameters to specify the IP addresses of up to three
network servers containing TACACS+ server software. After you
have entered an IP address, you see the following prompt:
Use per-server secret [Y/N] ->
If you are specifying more than one TACACS+ server and if all of
the servers use the same encryption secret, you can answer No to
this prompt and enter the encryption secret using the 5 - TAC
Global Secret parameter.
Allied Telesyn AT-8400 Series - ATS60 V2.0.0
High School Switch 142
User: Manager 00:14:36 01-Jan-2003
TACACS+ Client Configuration
1 - TAC Server 1 .................. 0.0.0.0
2 - TAC Server 2 .................. 0.0.0.0
3 - TAC Server 3 .................. 0.0.0.0
4 - TAC Server Order .............. 1 2 3
5 - TAC Global Secret .............
6 - TAC Timeout ................... 30 seconds
R - Return to Previous Menu
Enter your selection?