Allied Telesis AT-S60 - Manual (Page 412)

AT-S60 Management Software User’s Guide
Section III: Security Features 411
Enabling and Disabling Port Access Control
To globally enable or disable Port Access Control, perform the following
procedure:
Note
Enabling or disabling Port Access Control can only be performed in
a local management session.
Note
Before activating this feature, you must have the RADIUS EAP
specified and enabled as the authentication method. This is
discussed in Enabling TACACS+ or RADIUS on page 399.
1. From the Main Menu, type 6 to select Security Menu.
The Security Menu is shown in Figure 30 on page 105.
2. From the Security Menu, select Port Access Control.
The Port Access Control Menu is shown in Figure 144.
Figure 144 Port Access Control Menu
3. Type 1 to select Port Access Control. The following prompt is
displayed:
Port Access Control (E-Enable, D-Disable) ->
Allied Telesyn AT-8400 Series - ATS60 V2.0.0
High School Switch 142
User: Manager 00:14:33 22-Mar-2003
Port Access Control
1 - Port Access Control .............. Enabled
2 - Authentication Method ............ RADIUS EAP
3 - Configure Port Access Role
4 - Configure Authenticator
5 - Configure Supplicant
6 - Display Port Access Status
R - Return to Previous Menu
Enter your selection?