Allied Telesis AT-S60 - Manual (Page 204)

AT-S60 Management Software User’s Guide
Section II: Local and Telnet Management 203
Displaying STP
Port Settings
To display port STP settings, perform the following procedure:
1. From the Spanning Tree Menu, type 3 to select STP Configuration.
The STP Menu is shown in Figure 68 on page 199.
2. From the STP Menu, type P to select STP Port Parameters.
The STP Port Parameters Menu is shown in Figure 69 on page 201.
3. From the STP Port Parameters Menu, type 2 to select Display STP Port
Configuration.
The Display STP Port Configuration Menu is shown in Figure 71.
Figure 71 Display STP Port Configuration Menu
Allied Telesyn AT-8400 Series - ATS60 V2.0.0
High School Switch 142
User: Manager 00:14:33 15-Jan-2003
Display STP Port Configuration
Port State Cost Priority
----------------------------------------------
1.1 Disabled Auto-Update 128
1.2 Disabled Auto-Update 128
1.3 Disabled Auto-Update 128
1.4 Disabled Auto-Update 128
1.5 Disabled Auto-Update 128
1.6 Disabled Auto-Update 128
1.7 Disabled Auto-Update 128
1.8 Disabled Auto-Update 128
N - Next Page
U - Update Display
R - Return to Previous Menu
Enter your selection?