Allied Telesis AT-S60 - Manual (Page 147)

Chapter 10: File System Configuration
Section II: Local and Telnet Management 146
Displaying System Files
Use this procedure to display a list of current system files. You can use
this procedure to display certificate, configuration, image, and key files.
For information about shortcuts for specifying file names, see File
Naming Conventions on page 135.
To display a list of current system file names, perform the following
procedure:
1. From the Main Menu, type 9 to select File Menu.
The File Menu is shown in Figure 40 on page 138.
2. From the File Menu, type 5 to select Display files to display a list of
system files.
The following prompt is displayed:
Enter File Name to list:
3. Enter a configuration file name.
You can enter up to 16 alphanumeric characters followed by a
three letter extension. In addition, special characters, such as *, are
permitted. For example, to display the current list of certificate
files, enter:
*.cer
To display the current list of configuration files, enter:
*.cfg
To display the current list of key files, enter:
*.key
To display the system files that begin with the letter t, enter:
t*.*