Allied Telesis AT-S60 - Manual (Page 571)

Chapter 39: 802.1x Port-Based Network Access Control
Section IV: Web Browser Management 570
Reauth Period
Enables periodic re-authentication of the client, which is disabled
by default. The default value is 3,600 seconds. The range is from 1
to 65,535 seconds.
Server Timeout
This is the timer used by the switch to determine authentication
server timeout conditions. The default value is 30 seconds. The
range is from 1 to 65,535 seconds.
6. Click Apply to save the settings and close the page. If you click Close,
the page is closed but the settings are not saved.
Configuring a
Supplicant Port
To configure a supplicant port, perform the following procedure:
1. On the Home page, select Configuration.
The Configuration System page is displayed with the General tab
shown by default.
2. Select the Layer 1 option.
The Layer 1 page is shown with the Port Settings tab shown by
default.
3. Select the 802.1x Port Access tab.
The Configuration 802.1x Port Access tab is displayed as shown in
Figure 218 on page 566.
Note
You must set up the port role as supplicant before you can configure
a supplicant port.
4. Click on a supplicant port or ports and click Settings.