Brocade Network OS Administrator’s Guide v4.1.1 - Manual (Page 93)

Displaying the hardware profile configuration default profile in fabric
cluster mode
The following shows the use of the show hardware-profile command in fabric
cluster mode, with the current keyword to show the results of a default profile on
a Brocade VDX 6740.
switch# show hardware-profile current
rbridge-id: 1 switch type: BR-VDX6740
current route-table profile: DEFAULT
_________________________________________________
IPV4 Max Routes 4096
Max Next-hops 1024
IPV6 Max Routes
1024
IPV4 Max Neighbor cache (ARPs) 16384
IPV6 Max Neighbor cache (ND) 4096
IPV4 Max Multicast Routes 1024
IPV6 Max Multicast Routes 100
IGMP Snooping Entries 1024
MLD Snooping Entries 1024
PIM IPV4 Register Encap Entries 1024
PIM IPV4 Register Decap Entries 1024
PIM IPV6 Register Encap Entries 1024
PIM IPV6 Register Decap Entries 1024
FCoE Domain Routes and SAN routing 2048
current TCAM profile: DEFAULT
________________________________________________
LDEV_L2PSEL_SYS 512
LDEV_L2PSEL_FCOE 512
LDEV_L2PSEL_QOS 512
LDEV_L2PSEL_FWD 512
LDEV_L2PSEL_ACL 512
LDEV_IPV4PSEL_QOS 512
LDEV_IPV4PSEL_MCAST 3072
LDEV_IPV4PSEL_PBR 512
LDEV_IPV4PSEL_ACL 512
LDEV_L3PSEL_FCOE 512
LDEV_L3FWD_IPV4 4096
LDEV_L3FWD_FCOE 2048
LDEV_L3FWD_IPV6 1024
LDEV_L2EACL 128
LDEV_L2EACL_SPAN 256
LDEV_IPV4EACL 512
LDEV_FCOEEACL 128
LDEV_IPV4_MCUID_OVFLW 2048
LDEV_L2_MAC_CLASS_VID 256
LDEV_ING_VPN_CLASS 4096
LDEV_L3CTRL_CLASS 128
LDEV_TYPE_VLAN_CLASS 256
Displaying the hardware profile in fabric cluster mode
In fabric cluster mode, the keywords for the show hardware-profile route-table
and the show hardware-profile tcam commands are identical to those listed in
the tables in
Configuring policy-based resource management on page 89.
Displaying the hardware profile in logical chassis cluster mode
In logical chassis cluster mode, the keywords for the show hardware-profile
route-table and the show hardware-profile tcam commands are identical to
those listed in the tables in
Configuring policy-based resource management on
page 89. In addition, in this mode you can view the profile details on any online
switches in the cluster by specifying the RBridge ID. If the rbridge-id keyword is
not used, results are returned for the local switch only.
Basic Switch Management
Network OS Administrator’s Guide 93
53-1003225-04