Brocade Network OS Administrator’s Guide v4.1.1 User Manual
Page 727

Unsupported Network OS CLI commands in privileged EXEC mode (Continued)
TABLE 108
Command name
Command Description
show cee maps
Displays CEE maps.
show cipherset
Displays ciphers for LDAP and SSH.
show cli
Displays CLI session parameters.
show clock
Displays the date and time settings.
show diag
Displays diagnostic information.
show dot1x
Displays IEEE 802.1X Port-Based Access Control configuration data.
show edge-loop-detection globals Displays system-wide Edge-Loop-Detection status information.
show fcoe login
Displays the FCoE CNA Login information.
show file
Displays the contents of a file.
show history
Displays command history.
show interface
Displays interface status and configuration.
show ip
Displays Internet Protocol (IP) information.
show lacp counter
Displays Link Aggregation Control Protocol (LACP) counters.
show lldp
Displays Link Layer Discovery Protocol (LLDP) configuration data
show monitor
Displays interface status and configuration.
show netconf-state
Displays NETCONF statistics.
show ntp
Displays the active NTP server.
show parser dump
Displays a parser dump.
show policy-map
Displays the configured rate-limiting policy maps.
show port
Displays port parameters.
show port-channel
Displays the port-channel configuration.
show port-profile
Displays the port profile configuration
show qos
Display the Quality of Service (QoS) configuration.
show running-config
Displays the running configuration.
show sflow
Displays the sFlow configuration.
show spanning-tree
Displays the Spanning Tree Protocol configuration.
TACACS+ Accounting Exceptions
Network OS Administrator’s Guide
727
53-1003225-04