beautypg.com

Brocade Network OS Administrator’s Guide v4.1.1 User Manual

Page 708

background image

1. Enter the show running-config interface command to determine which interfaces have trunking

enabled.

switch# show running-config interface

interface Management 66/0

no ip address dhcp

ip address 10.24.81.66/20

ip route 0.0.0.0/0 10.24.80.1

ipv6 address ""

no ipv6 address autoconfig

!

interface TenGigabitEthernet 66/0/1

fabric isl enable

fabric trunk enable

no shutdown

!

interface TenGigabitEthernet 66/0/2

fabric isl enable

fabric trunk enable

no shutdown

!

interface TenGigabitEthernet 66/0/3

fabric isl enable

fabric trunk enable

no shutdown

!

(output truncated)

2. Verify the status of the ISL port and link.

a)

Enter the show fabric isl command to verify whether the ISL is up.

b)

Enter the show fabric islports command to examine the status of each port.

Refer to

Verifying the status of ISLs

on page 686 for details and corrective action.

3. Enter the show interface command for each trunk link and examine the rate information to check

for an equal distribution of traffic on the interfaces in the trunk. The rate information is shown
underlined in the following example.

switch# show interface tengigabitethernet 66/0/12

TenGigabitEthernet 66/0/12 is up, line protocol is down (link protocol down)

Hardware is Ethernet, address is 0005.3367.26a8

Current address is 0005.3367.26a8

Pluggable media not present

Interface index (ifindex) is 283871281409

MTU 2500 bytes

LineSpeed Actual : Nil

LineSpeed Configured : Auto, Duplex: Full

Flowcontrol rx: off, tx: off

Last clearing of show interface counters: 1d00h42m

Queueing strategy: fifo

Receive Statistics:

0 packets, 0 bytes

Unicasts: 0, Multicasts: 0, Broadcasts: 0

64-byte pkts: 0, Over 64-byte pkts: 0, Over 127-byte pkts: 0

Over 255-byte pkts: 0, Over 511-byte pkts: 0, Over 1023-byte pkts: 0

Over 1518-byte pkts(Jumbo): 0

Runts: 0, Jabbers: 0, CRC: 0, Overruns: 0

Errors: 0, Discards: 0

Transmit Statistics:

0 packets, 0 bytes

Unicasts: 0, Multicasts: 0, Broadcasts: 0

Underruns: 0

Errors: 0, Discards: 0

Rate info (interval 299 seconds):

Input 0.000000 Mbits/sec, 0 packets/sec, 0.00% of line-rate

Output 0.000000 Mbits/sec, 0 packets/sec, 0.00% of line-rate

Time since last interface status change: 1d03h16m

4. Having found a trunk member that carries no traffic while the other trunk members are busy, from

the same show interface command output, check the interface status, configuration, and error
statistics.

Troubleshooting procedures

708

Network OS Administrator’s Guide

53-1003225-04