Brocade Network OS Administrator’s Guide v4.1.1 - Manual (Page 654)

Displaying IP DHCP Relay addresses for an interface
You can display IP DHCP Relay addresses configured on a specific interfaces of a local switch,
specific RBridge, or all RBridge IDs in a logical chassis cluster.
To display the IP DHCP Relay addresses configured for a switch interface, use the show ip dhcp
relay address interface command followed by the interface ID to display IP DHCP Relay addresses
configured on a specific interface.
1. Access a switch where an IP DHCP Relay has been configured on an interface.
2. In privileged EXEC mode, issue the show ip dhcp relay address interface command followed by
the interface ID.
Example: Displaying addresses for local switch interfaces
The following is an example for a 10GbE interface of a local switch.
sw0# show ip dhcp relay address interface te 1/0/24
RBridge Id: 1
----------------
Interface Relay Address VRF Name
--------- ------------- --------
Te 1/0/24 10.3.4.5 Blue
Te 1/0/24 10.5.1.1 Blue
Example: Displaying addresses for a specific interface
The following is an example for a Virtual Ethernet interface on a specific switch
(RBridge ID 1).
sw0# show ip dhcp rel add int ve 300 rbridge-id 1
RBridge Id: 1
----------------
Interface Relay Address VRF Name
--------- ------------- --------
Ve 300 10.0.1.2 default-vrf
Displaying IP DHCP Relay addresses for an interface
654 Network OS Administrator’s Guide
53-1003225-04