beautypg.com

Configuring and managing lldp, Understanding the default lldp, Enabling lldp globally – Brocade Network OS Administrator’s Guide v4.1.1 User Manual

Page 453: Disabling lldp globally

background image

Configuring and managing LLDP

The following sections discuss working with the Link Layer Discovery Protocol (LLDP) on Brocade
devices.

Understanding the default LLDP

The following table lists the default LLDP configuration. Consider this when making changes to the
defaults.

Default LLDP configuration

TABLE 74

Parameter

Default setting

LLDP global state

Enabled

LLDP receive

Enabled

LLDP transmit

Enabled

Transmission frequency of LLDP updates

30 seconds

Hold time for receiving devices before discarding

120 seconds

DCBX-related TLVs to be advertised

dcbx-tlv

Enabling LLDP globally

The protocol lldp command enables LLDP globally on all interfaces unless it has been specifically
disabled on an interface, or the global LLDP disable command has been executed. LLDP is globally
enabled by default.

To enable LLDP globally, perform the following steps from privileged EXEC mode.

1. Enter the configure terminal command to change to global configuration mode.

switch# configure terminal

2. Enter LLDP configuration mode.

switch(config)# protocol lldp

3. Enter the copy running-config startup-config command to save your configuration changes.

Disabling LLDP globally

LLDP is enabled globally by default. These instructions allow you to disable LLDP globally without
changing any other aspect of the LLDP configuration.

NOTE
The disable command executed in LLDP protocol configuration mode disables LLDP globally. To re-
enable LLDP, refer to

Enabling LLDP globally

on page 453.

To disable LLDP globally, perform the following steps from global configuration mode.

Configuring and managing LLDP

Network OS Administrator’s Guide

453

53-1003225-04