Brocade Network OS Administrator’s Guide v4.1.1 - Manual (Page 223)

Displaying port mapping
You can display current and configured VF_Port to N_Port mapping on a specific switch or on all
switches enabled for Access Gateway in the VCS cluster.
Access Gateway and must be enabled for this command to succeed.
Display current, active VF_Port to N_Port mapping on a specific switch or on all switches enabled for
Access Gateway in the VCS cluster using the show ag map rbridge-id rbridge-id command while in
Privileged EXEC mode.
Display configured VF_Port to N_Port mapping on a switch using the show running-config rbridge-id
rbridge id ag command.
1. Determine N_Port numbering for your switch model using the table in Default port mapping on page
225.
2. Perform one of the following steps while in privileged EXEC mode:
• To display current, active, VF_Port mapping for a specific N_Port, enter show ag map nport
rbridge-id rbridge-id.
switch# show ag map rbridge-id 5/0/1 rbridge-id 5
• To display current, active VF_Port mapping to all N_Ports on a switch, enter show ag map
rbridge-id rbridge-id.
switch# show ag map rbridge-id rbridge-id 5
• To display VF_Port mapping to a N_Ports on all switches in the VCS cluster, enter show ag map
rbridge-id all.
switch# show ag map rbridge-id all
• To display configured mapping on a switch, enter show running-config rbridge-id rbridge id ag.
switch# show running-config rbridge-id 1 ag
Displaying port mapping
Network OS Administrator’s Guide 223
53-1003225-04