Brocade Network OS Administrator’s Guide v4.1.1 User Manual
Page 119

4. At the Do Auto-Commit after Reboot [y/n]: prompt, enter n if you want to commit the
firmware manually after downloading the firmware.
switch# firmware download interactive
Server name or IP address: 10.31.2.25
File name: /users/home40/Builds/NOS_v4.1.0
Protocol (ftp, scp): ftp
User: fvt
Password: **********
Do manual download [y/n]: y
Reboot system after download? [y/n]:n
Do Auto-Commit after Reboot? [y/n]:n
System sanity check passed.
You are running firmware download on dual MM system with 'manual' option. This
will upgrade the firmware only on the local MM.
Do you want to continue? [y/n]:y
(output truncated)
5. After download completes, enter the show version all-partitions command to confirm that the
primary partitions of the switch contain the new firmware.
6. If you entered n after the Reboot system after download? prompt, enter the reload command
to reboot the switch. If you entered y after the prompt, the switch will reboot automatically. The switch
performs a reboot and comes up with the new firmware. Your current CLI session will automatically
disconnect.
7. Log back into the switch. If you entered n in the Do Auto-Commit after Reboot? prompt, enter
the firmware commit command to commit the new firmware. If you entered y after the prompt, the
switch will commit the firmware automatically upon booting up.
switch# firmware commit
Validating primary partition...
Doing firmwarecommit now.
Please wait ...
Replicating kernel image
...............
FirmwareCommit completes successfully.
8. Enter the show version command with the all-partitions option. Both partitions on the switch or on
the modules should contain the new firmware.
Downloading firmware by using the default-config option
You can download firmware on a local switch and optionally change the VCS mode, the VCS ID, and
the RBridge ID before rebooting the switch with the new firmware.
To download firmware by using the default-config option with VCS mode 1, VCS ID 7, and RBridge 10,
use the following command:
sw0# firmware download default-config ftp host 10.20.1.3 user fvt password pray4green
directory dist file release.plist vcs-mode 1 vcs-id 7 rbridge-id 10
Performing system sanity check...
This command will set the configuration to default and set the following parameters:
vcs-mode, vcs-id and rbridge-id.
This command will cause Cold reboot on both MMs at the same time and will require
that existing telnet, secure telnet or SSH sessions be restarted.
Do you want to continue? [y/n]: y
Monitoring and verifying a firmware download session
Regardless of the options that you invoke, while the upgrade is proceeding you can start a separate CLI
session on the switch and use the show firmwaredownloadstatus command to monitor the progress
of the upgrade.
Downloading firmware by using the default-config option
Network OS Administrator’s Guide
119
53-1003225-04