Ampp scalability, Ampp port-profiles, Ampp scalability ampp port-profiles – Brocade Network OS Administrator’s Guide v4.1.1 User Manual
Page 329

destination port as the profiled port, or the reverse. SPAN allows the capability to mirror the traffic learnt
on the profiled port.
For complete information on SPAN, refer to
Configuring Switched Port Analyzer
on page 533.
AMPP scalability
The following table describes the Auto Migrating Port Profile (AMPP) scalability values supported by
Network OS 4.0.0.
AMPP scalability values
TABLE 55
Metric
Logical chassis mode
Fabric cluster mode
Number of profiles
750
750
Number of VLANs in port-profiles
2000
2000
QoS profile
1 cee-map
1 mutation-map
1 cee-map
1 cos-mutation-map
Number of ACLs in security profiles
Same as Layer 2 ACL
Same as Layer 2 ACL
Number of MAC associations
8000 (4000 for Brocade VDX 6710.)
8000 (4000 for Brocade VDX 6710.)
The MAC and VLAN scaling numbers in the previous table are based on mac-association and vlan-
profile scaling without any ACL configuration. In addition, AMPP is subject to the maximum number of
vLAGs and LAGs supported on the switch, which is 750 in this case.
AMPP port-profiles
As shown in the following figure, the default port-profile contains the entire configuration needed for a
VM to get access to the LAN and SAN.
FIGURE 40 Port-profile contents
AMPP scalability
Network OS Administrator’s Guide
329
53-1003225-04