beautypg.com

Using show commands – Brocade Network OS Administrator’s Guide v4.1.1 User Manual

Page 718

background image

From the output, choose the source and destination MAC address:

• Source MAC address: 0050.5685.0003
• Destination MAC address: 0024.3878.e720

2. Enter the l2traceroute command.

switch2# l2traceroute

Source mac address : 0050.5685.0003

Destination mac address : 0024.3878.e720

Vlan [1-3962] : 101

Edge rbridge-id [1-239] : 3

Extended commands [Y/N]? : y

Protocol Type [IP] : IP

Source IP address : 101.101.101.10

Destination IP address : 101.101.101.101

IP Protocol Type [TCP/UDP] : TCP

Source port number [0-65535] : 3000

Dest port number [0-65535] : 22

Rbridge Ingress Egress Rtt(usec)

----------------------------------------------------------------------------

3 Te 3/0/1(std-lag, Po 1) Te 3/0/20(isl) 0

2 Te 2/0/20(isl) Te 2/0/9(std-lag, Po 11) 34041

Be advised of the following points:

• The MAC addresses used should be present in the MAC address-table (dynamic or static).
• The l2traceroute command can be used in VCS Fabric mode only.
• Make use of IP parameters to influence path selection.

Using show commands

The table below lists some show commands that are often used for troubleshooting. Refer to the
Network OS Command Reference for details of all show commands.

show commands used for troubleshooting

TABLE 104

Command group

Commands

Specific fields or purpose

System commands

show system

show license

show running-config

show startup-config

show logging raslog

show version

show chassis

show environment

show vlan brief

show mac-address-table

show process cpu

show process memory

show firmwaredownloadstatus

Using show commands

718

Network OS Administrator’s Guide

53-1003225-04