Brocade Network OS Administrator’s Guide v4.1.1 - Manual (Page 524)

The gigabitethernet rbridge-id/slot/port operand is used only for the Brocade VDX 6710, VDX
8770-4, and VDX 8770-8. The prompt for these ports is in the following format: switch(config-if-
gi-22/0/1)#.
switch(config)# interface tengigabitethernet 1/12
3. To check 802.1x authentication statistics on specific interface ports, use the show dot1x command
with the statistics interface keyword.
switch# show dot1x statistics interface tengigabitethernet 1/12
4. To check all diagnostics information of the authenticator associated with a specific interface port,
use the show dot1x command with the diagnostics interface keyword.
switch# show dot1x diagnostics interface tengigabitethernet 1/12
5. To check all statistical information of the established session, use the show dot1x command with
the session-info interface keyword.
switch# show dot1x session-info interface tengigabitethernet 1/12
Configuring 802.1x Port Authentication
524 Network OS Administrator’s Guide
53-1003225-04