beautypg.com

Disabling flow-based sflow on specific interfaces – Brocade Network OS Administrator’s Guide v4.1.1 User Manual

Page 531

background image

Disabling flow-based sFlow on specific interfaces

To disable sFlow on a specific interface, perform the following steps in interface configuration mode.

NOTE
Disabling sFlow on an interface port does not completely shut down the network communication on the
interface port.

1. Disable the sFlow interface.

switch(conf-if)# no sflow enable

2. Return to privileged EXEC mode.

switch(conf-if)# end

3. Switch to interface configuration mode.

switch(config-policymap-class)# exit

switch(config)# interface ten 1/8/1

switch(conf-if-te-1/8/1)#

4. Disable flow-based sFlow by removing the policy map.

switch(conf-if-te-1/8/1)# no service-policy in

5. Confirm the sFlow configuration status on the specific interface.

NOTE
The gigabitethernet rbridge-id/slot/port operand is used only for the Brocade VDX 6710, VDX
8770-4, and VDX 8770-8. The prompt for these ports is in the following example format:
switch(config-if-gi-22/0/1)#.

switch# show sflow interface tengigabitethernet 0/12

Disabling flow-based sFlow on specific interfaces

Network OS Administrator’s Guide

531

53-1003225-04