Brocade Network OS Administrator’s Guide v4.1.1 User Manual
Page 221

NOTE
Display of current, active mapping, or configured mapping for a port group using the show ag rbridge-
id rbridge-id and show running-config rbridge-id rbridge-id ag commands depend on the enabled or
disabled state of Login Balancing mode. For more information, refer to
Automatic Login Balancing Mode
on page 230.
1. Make sure you are in Privileged EXEC mode and have a switch prompt such as the following.
switch#
2. Perform one of the following steps:
• Enter the show running-config rbridge-id rbridge-id ag command as in the following example for
RBridge 1.
switch# show running-config rbridge-id 1 ag
• Enter the show ag rbridge-id rbridge-id command as shown in the following example for RBridge
5.
switch# show ag rbridge-id 5
If Access Gateway is enabled, data such as the following displays for show running-config rbridge-
id rbridge-id ag, as shown in the following example for RBridge 1:
switch# show running-config rbridge-id 1 ag
rbridge-id 1
ag
nport 1/0/1
map fport interface Fcoe 1/1/1 1/1/9 1/1/17 1/1/25 1/1/33 1/1/41 1/1/49 1/1/57
!
nport 1/0/2
map fport interface Fcoe 1/1/2 1/1/10 1/1/18 1/1/26 1/1/34 1/1/42 1/1/50 1/1/58
!
nport 1/0/3
map fport interface Fcoe 1/1/3 1/1/11 1/1/19 1/1/27 1/1/35 1/1/43 1/1/51 1/1/59
!
nport 1/0/4
map fport interface Fcoe 1/1/4 1/1/12 1/1/20 1/1/28 1/1/36 1/1/44 1/1/52 1/1/60
!
nport 1/0/5
map fport interface Fcoe 1/1/5 1/1/13 1/1/21 1/1/29 1/1/37 1/1/45 1/1/53 1/1/61
!
nport 1/0/6
map fport interface Fcoe 1/1/6 1/1/14 1/1/22 1/1/30 1/1/38 1/1/46 1/1/54 1/1/62
!
nport 1/0/7
map fport interface Fcoe 1/1/7 1/1/15 1/1/23 1/1/31 1/1/39 1/1/47 1/1/55 1/1/63
!
nport 1/0/8
map fport interface Fcoe 1/1/8 1/1/16 1/1/24 1/1/32 1/1/40 1/1/48 1/1/56 1/1/64
!
pg 0
nport interface FibreChannel 1/0/1 1/0/2 1/0/3 1/0/4 1/0/5 1/0/6 1/0/7 1/0/8
modes lb
rename pg0
!
timeout fnm 120
counter reliability 25
If Access Gateway is enabled, data such as the following displays for show ag rbridge-id rbridge-id,
as shown in the following example for RBridge 5:
switch# show ag rbridge-id 5
RBridge-ID 5:
----------------------------------------------------------------------------------
Name : sw0
NodeName : 10:00:00:05:33:f4:78:04
Number of Ports : 32
IP Address(es) : 10.37.209.80
Firmware Version : v4.1.0pgoel_pit02_nos4_1_10_10
Number of N_Ports(Fi) : 2
Number of VF_Ports : 0
Policies Enabled : pg
Persistent ALPA : Disabled
Using Access Gateway
Network OS Administrator’s Guide
221
53-1003225-04