beautypg.com

Using fibre channel port commands – Brocade Network OS Administrator’s Guide v4.1.1 User Manual

Page 202

background image

Configuring and viewing Fibre Channel port attributes

This section introduces the options for configuring a variety of Fibre Channel port attributes and
confirming the status of those attributes.

Using Fibre Channel port commands

Network OS v2.1.1 and later allows you to configure and display the following Fibre Channel port
attributes for an E_Port by using the commands shown below:

• Port speed — Enter the interface Fibre Channel configuration submode speed command to set the

speed of a Fibre Channel port.

• Fill word — Enter the interface Fibre Channel configuration submode fill-word command to

configure the link initialization and fill word primitives for an 8-gbps Fibre Channel port.

• Long distance mode — Enter the interface Fibre Channel configuration submode long-distance

command to configure the port for long-distance operations.

• VC link init — Enter the interface Fibre Channel configuration submode vc-link-init command to

configure the fill word for long-distance operation.

• Desired distance — Enter the interface Fibre Channel configuration submode desire-distance

command to configure manually the distance for a long-distance connection.

• Trunk port — Enter the interface Fibre Channel configuration submode trunk-enable command to

configure the port for trunking.

NOTE
Port trunking is not supported in Access Gateway Mode.

• Buffer credit control — Enter the interface Fibre Channel configuration submode isl-r_r-rdy

command to enable interswitch link receiver-ready (ISL R_RDY) mode on the port. Enter the
interface Fibre Channel configuration submode no isl-r_r-rdy command to disable ISL R_RDY
mode on the port. If ISL R_RDY is not set, then Inter-SwitchLink Virtual Channel ready (ISL
VC_RDY) mode is set by default.

ATTENTION
Setting ISL R_RDY is not recommended.

The following Fibre Channel port attributes are not supported by Network OS 4.1.0:

AL_PA offset 13

Compression

Credit Recovery

CSCTL mode

D-Port mode

Disabled E_Port

Encryption

EX_Port

F_Port buffers

Fault Delay

FEC

Frame shooter port

Locked G_Port

Locked L_Port

LOS TOV enable

Mirror Port

NPIV capability

NPIV PP Limit

Persistent Disable

Port Auto Disable

QoS E_Port

Rate limit

RSCN suppressed

Configuring and viewing Fibre Channel port attributes

202

Network OS Administrator’s Guide

53-1003225-04