Brocade Network OS Administrator’s Guide v4.1.1 - Manual (Page 46)

Considerations for show command output
Network OS contains many versions of the show command. The output of the show command
changes depending on your configuration and situation. However, in general terms the show
command falls into one of two categories:
• Any show commands that are fabric (global configuration) in nature, such as VLAN, MAC Address
table, AMPP, Zoning, and so on, should display or clear the information for all nodes in a logical
chassis.
• Any show commands that are local to a switch, such as Layer 3 or Layer 2 functionality (for
example, sFlow, SPAN, and so on), should display the local information by default, and display
different switch information specific to an RBridge ID.
Considerations for show command output
46 Network OS Administrator’s Guide
53-1003225-04