IAI America TT-C3 - Manual (Page 322)

312
INTELLIGENT ACTUATOR
Appendix
Appendix
Other Parameters
No. Parameter name
Default value
(Reference)
Input range Unit Remarks
38 PC/TP data protect
setting (Symbol,
parameter) 0H 0H to
FFFFFFFFH
Bits 0 to 3: Protect type (Parameter) (0: Read/write, 1:
Read only, 2: No read/write)
Bits 4 to 7: Protect release method (Parameter) (0: Special
operation)
Bits 8 to 11: Protect type (Symbol) (0: Read/write, 1: Read
only, 2: No read/write)
Bits 12 to 15: Protect release method (Symbol) (0: Special
operation)
* Referenced by the PC/TP (PC software version 2.0.0.42 or
later and TP application version 1.09 or later)
39 (For future expansion) 0H 0H to
FFFFFFFFH
40 EEPROM information
check type
3H Reference only For adjustment by the manufacture
41 Hardware information
check type
E0H Reference only For adjustment by the manufacture
42 Hardware test type 7H Reference only For adjustment by the manufacture
43 Special monitor type 0H 0H to
FFFFFFFFH
Change strictly prohibited unless specified by the manufacturer.
44 (For expansion) 0
45 Special start condition
setting 0 0H to
FFFFFFFFH
Bits 0 to 3:
Enable start from PC/TP in AUTO mode = Used exclusively
by the manufacturer (0: Do not enable, 1: Enable)
Bits 4 to 7:
PIO program start (Input port 000)
Single start selection (0: Normal, 1: Single start)
* When single start is selected, the next PIO program start
(input port 000) will not be accepted as long as a program
with the same program number as the one started by the
last PIO program start (input port 000) is running.
Bits 8 to 11:
Permission of auto program start when all-operation-
cancellation factor is present
(0: Do not permit, 1: Permit)
Bits 12 to 15:
Permission of ON edge acceptance for PIO program start
(input port 000) when all-operation-cancellation factor is
present
(0: Do not permit, 1: Permit)
* This parameter specifies an ON-edge acceptance
condition. If the starting condition is not satisfied, an “Error
No. A1E: Start condition non-satisfaction error” will
generate.
PC: PC software
TP: Teaching pendant