IAI America TT-C3 - Manual (Page 27)

17
INTELLIGENT ACTUATOR
Chapter 1 Installation
2.
Speci
¿
cations
x X-axis actuator
Various loads can be attached to the X-axis actuator of the gate-type robot.
x Y-axis actuator
Various tools can be attached to the Y-axis actuator of the 2-axis robot.
x Z-axis actuator
Various tools can be attached to the Z-axis actuator of the 3-axis robot.
x T-groove
Auxiliary tools can be attached by utilizing the T-grooves/T-slots and nuts.
x Position adjustment volume
You can fine-tune the slider position easily by turning this volume with a flathead screwdriver, etc.
This function is useful when manually adjusting the slider position to read position data.
This adjustment volume is provided on various actuators.
(Note) Before fine-tuning the slider position using this volume, be sure to actuate an emergency
stop.
Do not insert an adjustment tool, finger or other object into the operating range of the robot
while the servo is ON or slider is operating.