Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set User Manual
Page 690

Paramacros
Chapter 20
20-46
4.
Select the softkey to alter the common parameter values.
(softkey level 3)
SEARCH
NUMBER
REPLCE
VALUE
ZERO
VALUE
0 ALL
VALUES
REFRSH
SCREEN
If you press the {COM-2A PARAM} softkey (in step 2), these
options are also available to alter the parameter name:
To edit an existing parameter name or enter a parameter name
for the first time for a local parameter, press the {REPLCE
NAME} softkey. Key in a parameter name for the parameter. A
name can be up to 8 characters long and include any alphanumeric
character with the exception of a few of the special symbols. After
the name is keyed in, press the [TRANSMIT] key. The new
parameter name is displayed next to the value of that parameter
To clear a parameter name so that no name is displayed next to
the parameter number on the screen, press the {CLEAR
NAME} softkey. The message “SELECT NAME TO CLEAR
AND PRESS TRANSMIT” appears. Select the name to clear and
press the [TRANSMIT] KEY. The currently selected parameter
name is deleted
To clear all of the parameter names that are listed on the
{COMMON 2A} screen, press the {CLEAR ALL NM} softkey.
The prompt “OK TO CLEAR ALL NAMES? (Y/N):” appears.
Press Y followed by the [TRANSMIT] key to delete all parameter
names. Press N followed by the [TRANSMIT] key to abort the
clear-all-name operation
Parameter names are only for display purposes. They have no real
function other than to permanently label a parameter value.
Parameter names and parameter values are retained for parameters
even after power is turned off.
5.
Select the softkey to alter the common parameter names.
(softkey level 3)
SEARCH
NUMBER
REPLCE
VALUE
ZERO
VALUE
REPLCE
NAME
CLEAR
NAME
CLEAR
ALL NM
0 ALL
VALUES
REFRSH
SCREEN