4 entering passwords – Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set User Manual

Page 50

Chapter 2
Operating the Control

2-30

If the

{ACCESS CONTRL}

softkey does not appear on the screen, the

currently active access level is not allowed to use the

{ACCESS CONTRL}

function. Enter a password that has access to

{ACCESS CONTRL}

Press the

{ACCESS CONTRL}

softkey. This displays the access control

screen (Figure 2.5).

(softkey level 2)

ACCESS

CONTRL

Press the

{STORE BACKUP}

softkey. This softkey appears in reverse

video and the message “STORING TO BACKUP -- PLEASE WAIT”
appears on the CRT until the control has finished storing the
password list to its backup memory.

(softkey level 3)

UPDATE

& EXIT

(NAME)

STORE

BACKUP

UPDATE

& EXIT

(NAME)

After storing the password list, the control returns to softkey level 2
and displays the message “STORED PASSWORD LIST TO
BACKUP” on line 2 of the CRT.

When the control is powered-up, the only functions that are available to the
operator are functions that are not protectable and functions that are
assigned to access level 8 (provided that the active level when power was
turned off was not assigned the power-up level feature). To access the
functions that are assigned to a specific access level, you must enter the
password that corresponds to that access level.

2.7.4
Entering Passwords